↓ Skip to main content
  1. Blog/
  2. Project Ananta/

Build Logs

Progress, experiments, design decisions, and failures from the development of Project Ananta.


Day 1: Starting the build (finally.)

 14th November 2026
#

After working out the initial ideas, being away for Diwali and other festival holidays, and a lot of procrastinating, I’m finally commencing work on Project Ananta. BTW, a belated Happy Diwali 🪔 to everyone reading!

The STM32G431 boards came without their headers soldered, so the first bit of hands-on work was soldering those.

Soldering the header pins
Me soldering the header pins.
STM32G431 board with the headers soldered
I think I did an OK job.

I then verified firmware flashing and USB serial console output on both boards. Flashing had an annoying error when leaving DFU mode after the download completed. Disabling automatic exit and resetting the board manually worked around it.

On the firmware side, I added a board-specific devicetree overlay to configure FDCAN1, including its RX/TX pins and clock source. The CAN controller initializes successfully, and I have configured loopback mode with a receive filter and message queue. Actual frame transmission and reception are still untested.

USB console showing CAN initialization and loopback setup
USB console confirming CAN initialization and loopback setup.

I also created a PROGRESS.md checklist in the repository so people can keep track of the work as it progresses.